Polishing set "gloss" Varnishes & Plastics | 4 parts for polishing stand | 300 mm
300 mm | Bore configurable
Contents: polishing discs | compounds
cut-buffing | high-gloss
Polishing-kit "high-gloss" for plastics and varnishes | polishing stand | 300mm
Four-piece high-gloss polishing-kit for plastics and varnishes, especially for stationary bench grinders or bench polishers. This polishing-kit reliably delivers a flawless high gloss and transparency on plastics and varnished surfaces.
Cut-buffing disc KONSTANT N16, diameter 300 mm with configurable bore
Vmax = 45 m/s, Umax = 2,900 rpm
High-gloss polishing wheel EFFEKTA N16, diameter 300 mm with configurable bore
Measure the pressure carefully! Too high contact pressure and/or too low speeds lead to overheating of the workpiece with uneven surfaces that can no longer be improved by polishing!
The evenly sanded and cleaned surface crosswise with the cut-buffing disc KONSTANT N16 together with Menzerna GW18 quickly pre-polish on lacquer and thermoset surfaces at approx. 20-25 m/s (1,300 - 1,600 rpm), on thermoplastic workpieces at approx. 10 -15 m/s (650 - 980 rpm) until an even, satin-matt surface without scratches and grooves is achieved on the workpiece
After polishing, clean the surface of abrasion and paste residues with a dry, soft and lint-free cloth. If necessary, degrease the workpiece with a tenside solution
The evenly pre-polished and cleaned surface in cross passes with a shank tool EFFEKTA FM230 together with Menzerna GW16 on lacquer and thermoset surfaces at approx. 20-25 m/s (1,300 - 1,600 rpm), on thermoplastic workpieces at approx. 10 -15 m/s (650 - 980 rpm) quickly polish to a high gloss
After polishing, clean the surface with a dry, soft, lint-free cloth. If necessary, degrease the workpiece with a tenside solution