Cut-Buffing Wheel | Sisal-Cotton SB-VR | 350 mm

Sisal-Cotton Plies

Diameter 350 x 25 mm

Bores 30 - 65 mm

For the polishing bench

Weight: kg
Incl. VAT (Total price depending on the VAT rate of the country of delivery), excl. Shipping Cost
  • Buy 5 for €85.65 each and save 3%
  • Buy 10 for €82.12 each and save 7%
  • Buy 25 for €77.70 each and save 12%
2-3 Days *
Item No.

Sisal-Cotton Cut-Buffing Discs SB-VR

SB-VR cut-buffing discs consist of a manifold of sisal sheets, each covered with cotton on both sides. Compared to the grinding work of pure sisal, sisal-cotton tools additionally display a surface smoothing effect due to the cotton inserts. Moreover, compared to other SB polishing discs, SB-VR polishing tools allow the highest counter pressure for improved effectiveness. As a result, SB-VR deliver matt to silky glossy surfaces, which in industrial practice are often further processed without requiring additional finish-buffing.


  • Thickness 25 mm, diameter 350 mm
  • Freely configurable holes 30 - 65 mm
  • Dense sisal fabric, double-sided with cotton and sewn
  • 10 layers sewn with concentric stitching circles made of natural linen thread
  • The quilted yarn wears off together with the sisal nettle trim without leaving any residue
  • Individually calibrated polishing discs for low-vibration concentricity and a smooth polishing pattern
  • Optionally with reinforced holes for frequent tool changes
  • Polishing tool for the stationary polishing stand
  • Vmax = 40 m/s, rmax = 2.200 min-1

Bore Holes

  • We manufacture your desired bore individually for you. We cover every known bore diameter for industrial polishing machines *
  • If you need other bore diameters or special adapters (e.g. for hexagonal shafts, with keyways, etc.), we will be happy to manufacture them on request **

* Polishing discs drilled individually at the customer's request are excluded from exchange or return in accordance with our Terms of Cancellation.

** Observe safety regulations for the minimum diameter of drive shafts!

Cut-Buffing Tools Selection

SI-W-PK SB-VR SB-4 SB-3 SB-XL Sisal-Cord
Attack SI-W-PK5 SB-VR3 SB-43 SB-33 SB-L3 Cord5
Flexi­bility SI-W-PK1 SB-VR1 SB-43 SB-32 SB-L4 Cord5
Cooling SI-W-PK1 SB-VR1 SB-43 SB-35 SB-L5 Cord4

Please select the type of cutting disc that best suits your polishing project from the above table (5 = "more" → 1 = "less")

Dressing of sisal polishing tools

  • Careful preparation of the polishing tool is a prerequisite for an optimal polishing result. Please follow our recommendations for dressing sisal polishing tools
  • Used polishing tools should also be dressed again on a regular basis. This applies in particular if residues of polishing paste have solidified or the polishing tools are heavily contaminated with material abrasion.

General Information on Polishing