Polishing set "gloss" aluminium | 4 parts for polishing stand | 200 mm
200 mm | Bore configurable
Contents: polishing discs | compounds
cut-buffing | high-gloss
Aluminium high-gloss polishing set for the polishing stand | 200mm
Four-piece high-gloss polishing set for aluminium, especially for stationary bench grinders or bench polishers. This polishing set reliably delivers the flawless high gloss characteristic of aluminum on carefully ground aluminum surfaces.
Sisal nettle pre-polishing disc SB-VR-10, diameter 200 mm with configurable bore
Vmax = 45 m/s, Umax = 4,300 rpm
High-gloss polishing wheel Effecta N2550, diameter 200 mm with configurable bore
Measure the pressure carefully! Too high contact pressure and/or too low speeds lead to overheating of the workpiece with uneven surfaces that can no longer be improved by polishing!
The evenly sanded and cleaned surface crosswise with the SB-VR-10 sisal nettle shaft tool together with Menzerna 439T quickly pre-polish at approx. 35-40 m/s (3,300 - 3,800 rpm) until an even, satin-matt surface without scratches and grooves is achieved on the workpiece
After polishing, clean the surface of abrasion and paste residues with a dry, soft and lint-free cloth. If necessary, degrease the workpiece with a suitable solvent or Viennese lime
The evenly pre-polished and cleaned surface in cross passes with a shank tool Effekta N2550 together with Menzerna 480BLF at approx. 30-35 m/s (2,850 - 3,300 rpm) quickly polish to a high gloss
After polishing, clean the surface with a dry, soft, lint-free cloth. If necessary, degrease the workpiece with a suitable solvent or Viennese lime