Polishing set "super-finish" Varnishes & Plastics | 4 parts for drill | 100 mm
100 mm | 6 mm shank
Contents: polishing discs | compounds
high-gloss | super-finish
Polishing-kit "super finish" for plastics and varnishes | drills | 100mm
The four-part super finish polishing-kit for plastics and varnishes enables hard-to-reach plastics or varnished components to be polished to a high gloss. This polishing set reliably delivers a flawless super finish on carefully prepared polymer surfaces.
Measure the pressure carefully! Too high contact pressure and/or too low speeds lead to overheating of the workpiece with uneven surfaces that can no longer be improved by polishing!
The evenly pre-polished and cleaned surface in cross passes with a shank tool EFFEKTA FM230 and Menzerna GW16 on lacquer and thermoset surfaces at approx. 20-25 m/s (3,800 - 4,900 rpm), on thermoplastic workpieces at approx. 10 -15 m/s (2,000 - 2,800 rpm) quickly polish to a high gloss
After polishing, clean the surface with a dry, soft, lint-free cloth. If necessary, degrease the workpiece with a tenside solution
The clean, mirror-polished surface using the EFFEKTA FM209 shank tool and Polish the Menzerna P175 on lacquer and thermoset surfaces at approx. 20-25 m/s (3,800 - 4,900 rpm), on thermoplastic workpieces at approx. 10 -15 m/s (2,000 - 2,800 rpm) quickly in cross passes to a super finish
The super finish Paste P175 only leaves an invisible microfilm on a flawless surface. To protect this surface, mechanical cleaning after superfinishing is usually avoided