Polishing set "Gloss" copper & brass | 4 parts for drill | 80 mm
80 mm | 6 mm shank
Contents: polishing discs | compounds
cut-buffing | high-gloss
Weight:
kg
Item No.
500-bm-cu-80-3
Brass & Copper "high gloss" polishing set for drills | 80mm
The four-part "high-gloss" polishing set for Brass & Copper enables high-gloss polishing of Brass & Copper components that are difficult to access in two consecutive steps. This polishing set reliably delivers the high gloss characteristic of Brass & Copper with a uniform line pattern on carefully ground Brass & Copper surfaces
Product features
- SB-VR-10 Sisal-Cotton shank tool, 80 x 6 mm
- Cotton shank tool N16, 80 x 6 mm
- Vmax = 30 m/s, Umax = 7,200 rpm
- Pre-polishing paste "Heavy Cut" Menzerna 456G (approx. 1.2 kg)
- Brass & Copper high gloss polishing paste Menzerna 480W (approx. 1.35 kg)
Application
- Wear protective equipment and follow safety regulations!
- Roughen the polishing discs before use using a suitable dressing tool
- Wet rotating tool sparingly with polishing paste
- Measure the pressure carefully! Too high contact pressure and/or too low speeds lead to overheating of the workpiece with uneven surfaces that can no longer be improved by polishing!
Step 1
- The evenly sanded and cleaned surface crosswise with the SB-VR-10 sisal nettle shaft tool together with Menzerna 456G quickly pre-polish at approx. 25-30 m/s (6,000 - 7,200 rpm) until the workpiece has an even, satin-matt surface without scratches or grooves
- After polishing, clean the surface of abrasion and paste residues with a dry, soft and lint-free cloth. If necessary, degrease the workpiece with a suitable solvent or Viennese lime
Step 2
- The evenly pre-polished and cleaned surface in cross passes with a cotton shank tool N16 together with Menzerna 480W at approx. 25-30 m/s (6,000 - 7,200 rpm) quickly polish to a high gloss
- After polishing, clean the surface with a dry, soft, lint-free cloth. If necessary, degrease the workpiece with a suitable solvent or Viennese lime