Polishing set "Gloss" Varnishes & Plastics | 4 parts for angle grinder M14 | 200 mm

Plastics and varnishes high-gloss polishing-kit | angle grinders | 200mm

Four-part plastics and varnishes high-gloss polishing-kit, especially for hand-held polishing machines or angle grinders with M14 mount. This polishing-kit reliably delivers a flawless high gloss and transparency on plastics and varnished surfaces.

Product features

• Cut-buffing disc KONSTANT 4-4 N16, diameter 200 mm x bore 14 mm
• V_max = 45 m/s, U_max = 4,300 rpm
• High-gloss polishing wheel EFFEKTA N16, diameter 200 mm x bore 14 mm
• V_max = 40 m/s, U_max = 3,800 rpm
• Pre-polishing paste "Heavy Cut" Menzerna GW18 (approx. 1.1 kg)
• High-gloss polishing compound Menzerna GW16 (approx. 1.3 kg)

Application

• Wear protective equipment and follow safety regulations!
• Roughen the polishing discs before use using a suitable dressing tool
• Wet rotating tool sparingly with polishing paste
• Measure the pressure carefully! Too high contact pressure and/or too low speeds lead to overheating of the workpiece with uneven surfaces that can no longer be improved by polishing!

Step 1

• The evenly sanded and cleaned surface crosswise with the cut-buffing disc KONSTANT N16 together with Menzerna GW18 quickly pre-polish on lacquer and thermoset surfaces at approx. 20-25 m/s (2,200 - 2,700 rpm), on thermoplastic workpieces at approx. 10 -15 m/s (1,100 - 1,600 rpm) until an even, satin-matt surface without scratches and grooves is achieved on the workpiece
• After polishing, clean the surface of abrasion and paste residues with a dry, soft and lint-free cloth. If necessary, degrease the workpiece with a tenside solution

Step 2

• The evenly pre-polished and cleaned surface in cross passes with the EFFEKTA FM230 polishing wheel together with Menzerna GW16 on lacquer and thermoset surfaces at approx. 20-25 m/s (2,200 - 2,700 rpm), on thermoplastic workpieces at approx. 10 -15 m/s (1,100 - 1,600 rpm) quickly polish to a high gloss
• After polishing, clean the surface with a dry, soft, lint-free cloth. If necessary, degrease the workpiece with a tenside solution